Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1
  • 2

TOPIC: F22 Raptor

F22 Raptor 1 year 3 months ago #1881

  • ahmetcalfe
  • ahmetcalfe's Avatar Topic Author
  • Offline
  • Administrator
  • Administrator
  • Posts: 294
  • Thank you received: 120
Ha ha, love it. A few more too to add now though.

Please Log in or Create an account to join the conversation.

F22 Raptor 1 year 2 months ago #1912

  • ahmetcalfe
  • ahmetcalfe's Avatar Topic Author
  • Offline
  • Administrator
  • Administrator
  • Posts: 294
  • Thank you received: 120
Here is a loose assembly of the some of the built up formers for the fuselage undersides, it has been slow progress so far and just putting these bits together show me that some mods need to be done already,. Oh well, I'll keep plugging away.

Attachments:
The following user(s) said Thank You: rogersimmonds

Please Log in or Create an account to join the conversation.

F22 Raptor 1 year 1 month ago #1922

  • ahmetcalfe
  • ahmetcalfe's Avatar Topic Author
  • Offline
  • Administrator
  • Administrator
  • Posts: 294
  • Thank you received: 120
Today's tricky little assembly, it will be cut into several pieces for each side of spine and above and below the horizontal split line. This former takes the ends of the lower nose sheeting, the base of the intakes and the lower outer sheeting for the main rear body. A bit of progress.

Attachments:

Please Log in or Create an account to join the conversation.

F22 Raptor 1 year 1 month ago #1928

  • ahmetcalfe
  • ahmetcalfe's Avatar Topic Author
  • Offline
  • Administrator
  • Administrator
  • Posts: 294
  • Thank you received: 120
Here's shot of a test build for one of the air intakes. I gave up trying to solve the complex geometry in 2D Autocad and took to pencil and paper. It is still not quite right but it has shown me how to do it better next time. Somehow I made it too short and some of the angles are wrong.
Attachments:

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
  • 2
Time to create page: 0.079 seconds
Powered by Kunena Forum