Welcome, Guest
Username: Password: Secret Key Remember me
  • Page:
  • 1
  • 2

TOPIC: Printed Tissue over Balsa - a new technique?

Printed Tissue over Balsa - a new technique? 1 month 2 weeks ago #1207

  • rogersimmonds
  • rogersimmonds's Avatar Topic Author
  • Offline
  • Administrator
  • Administrator
  • Posts: 327
  • Karma: 3
  • Thank you received: 55
Following my usual practice, the flying surfaces were offered up to the fuselage and the accuracy of alignment checked on a jig. Parameters checked ( amongst others) are: equal dihedral both sides; wings square to fuselage; tailplane square with fuselage and wings; fin in-line and vertical. Our little models can fly very fast so this is important!



Only then was glue applied and the various joints made good. The finished model (apart from the motor mount, foil and thrust tab) now weighs a tad under 25 grams ... not too bad:









:dry:

Please Log in or Create an account to join the conversation.

Printed Tissue over Balsa - a new technique? 1 month 2 weeks ago #1208

  • Daniel R
  • Daniel R's Avatar
  • Offline
  • Junior Member
  • Junior Member
  • Posts: 33
  • Thank you received: 13
Your finish is truly sublime Roger!
The following user(s) said Thank You: rogersimmonds

Please Log in or Create an account to join the conversation.

Printed Tissue over Balsa - a new technique? 1 month 1 week ago #1210

  • rogersimmonds
  • rogersimmonds's Avatar Topic Author
  • Offline
  • Administrator
  • Administrator
  • Posts: 327
  • Karma: 3
  • Thank you received: 55
I have detailed making the motor mount for the Talon on a separate thread, see:

Motor Mounts

The mount was glued in place, making sure it was in-line with the fuselage datum. The cocktail sticks key into the wing, so (I hope) the mount won't come off in a hard arrival. Car Plan foil behind the motor to protect the fuselage from the hot Rapier ... er Tendera TSPL-2L exhaust and a thin metal thrust tab complete the build:





Above: The T-38 Talon ready for its first test flight. It weighs a little under 32 grams with a used motor. I was pleased the CG came out in the right place without the need for nose (or tail!) weight.
In retrospect, trying out this technique of 'printed tissue over painted balsa' was an interesting exercise, but whether it was worth all the extra work I'm not sure. :S
The weight is slightly less than with printed 60 gsm Bond paper' over balsa and the tissue went on nicely, but the finish is not as good as I would have liked.

So it goes :huh:
Attachments:
The following user(s) said Thank You: Daniel R

Please Log in or Create an account to join the conversation.

Last Edit: by rogersimmonds.
  • Page:
  • 1
  • 2
Time to create page: 0.122 seconds
Powered by Kunena Forum